[Q77-Q96] HPE7-A08 Actual Questions 100% Same Braindumps with Actual Exam!

HPE7-A08 Actual Questions 100% Same Braindumps with Actual Exam!

HPE7-A08 Study Material, Preparation Guide and PDF Download

HP HPE7-A08 Exam Syllabus Topics:

Topic	Details
Topic 1	Install and Configure the Wired Network Solution: This domain evaluates the abilities of Network Engineers to provision and configure HPE Aruba Networking switches both via Aruba Networking Central and command-line interface. It covers physical switch setup, Layer 2 and Layer 3 configuration and validation, multicast features, security implementations, quality of service (QoS) settings, and integration of Aruba Networking solutions into existing environments.
Topic 2	Create the Implementation Plan for the Wired Network Solution: This section measures the skills of Network Designers who focus on understanding the HPE switching portfolio and selecting the right products to match various customer requirements. Candidates must also demonstrate the ability to create detailed and effective implementation plans based on given designs or customer scenarios to ensure successful wired network deployments.
Topic 3	Troubleshoot the Wired Network Solution: Candidates in this section, typically Network Support Specialists, are tested on identifying common wired network failures such as IP or VLAN mismatches, hardware issues, or port misconfigurations. It also involves analyzing performance problems caused by QoS or configuration errors and formulating effective remediation plans to restore correct network operations.
Topic 4	Manage, Maintain, Optimize, and Monitor the Wired Network Solution: This part measures the skills of Network Operations Engineers in managing and maintaining wired network infrastructures. It includes developing configuration management strategies, interpreting network operational data to make informed decisions, and programmatically auditing or configuring Aruba Networking switches to optimize performance and reliability.

 

NEW QUESTION # 77
Which logs should be reviewed after an unexpected network outage?
(Select two.)
Response:

• A. DHCP server logs
• B. Spanning-tree topology changes
• C. NetEdit backup logs
• D. VLAN pruning logs

Answer: B,C

NEW QUESTION # 78
Which are valid Layer 3 technologies in Aruba switches?
(Select two.)
Response:

• A. EIGRP
• B. OSPF
• C. STP
• D. BGP

Answer: B,D

NEW QUESTION # 79
In an attempt to clear the switch configuration, you've issued the command erase all zeroize. What is the result of this task?

• A. The switch runs a secure erase task, deleting the startup-config, and retains admin credential password.
• B. The switch clears all user credentials and retains the running configuration.
• C. The switch restores the factory-installed AOS-CX image to the switch.
• D. The switch runs a secure erase task, deleting all customer data, and may run up to an hour.

Answer: D

Explanation:
The command erase all zeroize performs a secure erase on the switch, which deletes all customer data including startup-config and stored credentials. This process can take up to an hour depending on the hardware and storage media.
It does not retain running config (Option A).
It does not restore the factory AOS-CX image (Option B).
Admin credentials are deleted as part of the secure erase (Option C is incorrect).
Therefore, this command securely wipes all data and resets the device.
References:
ArubaOS-CX Secure Erase and Factory Reset Guide
HPE Aruba Switch Maintenance Procedures
Aruba CX Switch CLI Reference

NEW QUESTION # 80
Which protocol is used to monitor and manage Aruba switches remotely using a standard network management system (NMS)?
Response:

• A. SNMP
• B. FTP
• C. BGP
• D. SSH

Answer: A

NEW QUESTION # 81
Examine the network exhibit.

A company has a guest implementation for wireless and wired access. Wireless access is implemented through a third-party vendor. The company is concerned about wired guest traffic traversing the same network as the employee traffic. The network administrator has established a GRE tunnel between AOS-CX switches where guests are connected to a routing switch in the DMZ.
Which feature should the administrator implement to ensure that the guest traffic is tunneled to the DMZ while the employee traffic is forwarded using OSPF?

• A. OSPF route maps using the "set metric" command
• B. User-based tunneling (UBT)
• C. Classifier policies
• D. Policy-based routing (PBR)

Answer: D

Explanation:
Guest traffic can be routed with PBR to use GRE tunnels that terminate in the DMZ.

NEW QUESTION # 82
Which switching technologies improve network resiliency?
(Select two.)
Response:

• A. EIGRP
• B. VLAN segmentation
• C. VSF
• D. Redundant power supplies

Answer: C,D

NEW QUESTION # 83
A network administrator is tasked to set up BGP in the company's network. The administrator is defining an eBGP peering between an AOS-CX switch and a directly-connected service provider.
The administrator has configured the following on the AOS-CX switch:

However, when using the "show bgp all summary" command, the state does not display
"Established" for the eBGP peer. What must the administrator configure to fix this issue?

• A. router bgp 64500 enable
• B. router bgp 64500 neighbor 192.168.1.1 update-source loopback0
• C. router bgp 64500 neighbor 192.168.1.1 ebgp-multihop
• D. router bgp 64500 address-family ipv4 unicast neighbor 192.168.1.1 activate

Answer: D

NEW QUESTION # 84
Which HPE Aruba switch series is recommended for data center deployments requiring high-speed fabric connectivity?
Response:

• A. Aruba 2530 Series
• B. Aruba 3810M Series
• C. Aruba 8320 Series
• D. Aruba 2930F Series

Answer: C

NEW QUESTION # 85
A recent routing change has caused an outage to one of your customer's branch sites. You are about to run the command below:
copy checkpoint 20240722 running-config
Which troubleshooting methodology does this exemplify?

• A. Top-down/Bottom-up
• B. Replace configuration
• C. Divide and conquer
• D. Spot the difference

Answer: B

Explanation:
Using the command copy checkpoint 20240722 running-config exemplifies the Replace configuration troubleshooting methodology. This involves replacing the current running configuration with a known good checkpoint to restore proper operation.
Divide and conquer isolates faults by segment.
Top-down/Bottom-up analyzes layer by layer.
Spot the difference compares configurations.
Replacing the config is a straightforward rollback approach.
References:
Aruba Configuration Management Guide
HPE Aruba Network Troubleshooting Methodologies
ArubaOS-CX CLI Reference

NEW QUESTION # 86
Which protocol should be configured to allow NetEdit to discover third-party devices?

• A. SNMP
• B. HTTPS
• C. HTTP
• D. SSH

Answer: A

NEW QUESTION # 87
Which Aruba Central features assist in monitoring switch health?
(Select two.)
Response:

• A. VLAN pruning
• B. AI-powered network analytics
• C. CLI-based manual debugging
• D. Device uptime monitoring

Answer: B,D

NEW QUESTION # 88
A company has a few servers in a secure, remote location storing highly-confidential documents connected to two AOS-CX 6400 switches configured in a VSX pair The AOS-CX switches perform access control with 802.1X and will be implementing user-based tunneling (UBT) so that Aruba gateway application inspection and stateful firewall policies can be applied to the traffic.
The gateways are running version 84 and implement the AP, PEF, and RFP licenses Which licensing is needed for the two AOS-CX switches?

• A. 2 AP, 2 PEF, and 2 RFP licenses only
• B. 1 AP license only
• C. 2 AP and 2 PEF licenses only
• D. 1 AP, 1 PEF, and 1 RFP licenses only

Answer: D

NEW QUESTION # 89
A network engineer is having a problem adding a custom-written script to an AOS-CX switch's NAE GUI. The script was written in Python and was successfully added on other AOS-CX switches. The engineer examines the following items from the CLI of the switch:

What should the engineer perform to fix this issue?

• A. Remove a script that is no longer used before installing the new script
• B. Install the script's signature before installing the new script
• C. Ensure the engineer's desktop and the AOS-CX switch are synchronized to the same NTP server
• D. Enable trust settings for the AOS-CX switch's SSL certificate

Answer: A

Explanation:
If switch and browser time is not in sync, only information displayed in the web ui might not be accurate.

NEW QUESTION # 90
Which feature enables a switch to automatically detect configuration drifts and restore previous settings?
Response:

• A. STP Guard
• B. Configuration auditing
• C. NetEdit Auto-Rollback
• D. VLAN auto-trunking

Answer: C

NEW QUESTION # 91
An administrator wants to drop traffic from VLAN 6 (10.1.6.0/24) to VLAN 5 (10.1.5.0/24), but allow all other traffic. What is correct configuration to accomplish this?

• A.
• B.
• C.
• D.

Answer: C

NEW QUESTION # 92
Which monitoring tools can be used to analyze switch performance?
(Select two.)
Response:

• A. Aruba NetEdit
• B. VLAN discovery tools
• C. SNMP-based monitoring tools
• D. Wireshark

Answer: A,C

NEW QUESTION # 93
Which Aruba tool allows for automated configuration deployment across multiple switches?
Response:

• A. NetEdit
• B. AirWave
• C. Aruba Central
• D. Wireshark

Answer: A

NEW QUESTION # 94
Which are valid configuration management strategies for Aruba switches?
(Select two.)
Response:

• A. Frequent backups
• B. Removing VLANs periodically
• C. Disabling logging
• D. Version control

Answer: A,D

NEW QUESTION # 95
Which methods are recommended for auditing switch configurations?
(Select two.)
Response:

• A. Using Aruba NetEdit for configuration comparison
• B. Blocking all unused ports
• C. Reviewing logs for configuration changes
• D. Resetting switches every month

Answer: A,C

NEW QUESTION # 96
......

HPE7-A08  Certification Study Guide Pass HPE7-A08 Fast: https://torrentvce.exam4free.com/HPE7-A08-valid-dumps.html